Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

service interval

Reset service light indicator Renault Safrane

Reset service light indicator Renault Safrane. How to reset maintenance light, reset oil service light. Can be made manually by use button on car dash board.

Reset service light indicator Renault Safrane. It was built in years: 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000.

1. The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
2. Turn ON the ignition, do not start the vehicle.
3. Push reset button until Spanner warning light symbol will start flash.
4. Keep button depressed until Spanner warning light symbol stops flashing and remains illuminated.
5. Indicator shows appropriate service interval.
6. Release reset button.
7. Turn OFF the ignition and then start your Renault Sfrane to see if spanner warning light has been reset.

Note. Some vehicles are fitted with a SERV lamp, this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).

BMW X5 2002 Oil Reset

BMW X5 Engine Oil Service reset

Turn the ignition to “0”
Press and hold odometer button and turn the ignition to “1”.
Hold odometer button pressed for approximately 5 seconds until the display shows: “Inspektion Re /
Release and press odometer button again until Reset flashes
Release and press odometer button shortly.
Release and press odometer button again.
The next oil service interval will be shown and will disappear.
Oil service lamp is now reset

Note: To abort the procedure at any time: turn the ignition to “0”.

Reset service light Renault Twingo 2007

The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:

Turn the Ignition ON (position 2) but do not start the engine

(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)

Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display

(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)

Press and hold the button

The display will now change to the new service interval and start flashing

Keep holding the button until the display stops flashing

Release the button

Categories





Copyright © 2013. All Rights Reserved.