Here’s how to do it yourself in no time works on a few different Jags….
Service Light Reset Instructions:
1 . Insert key into ignition.
2 . Press and hold the Reset switch (located on the Trip Computer Switchpack ).
3 . NOTE: The reset switch has to be released immediately after the ignition is switched ‘ON’. This is critical to enable the rest of the procedure.
Turn the key to Ignition position II and at the point of entering Ignition position II (i.e when a click is heard), instantaneously release the Reset switch.
4 . Wait one second.
5 . Press and hold the Trip switch (located on the end of the left-hand side stalk).
6 . Wait one second.
7 . Press and hold the Reset switch (whilst still holding the Trip switch).
8 . The cluster should display (within three seconds) the warning message ‘RESETTING SERVICE MODE’.
9 . Keep both buttons pressed until the warning message changes to ‘SERVICE MODE RESET’ (after ten seconds).
10 . Once the message is displayed the buttons may be released — sequence is now complete.
11 . If a Service Required message was displayed prior to the reset sequence, cycle the ignition to ‘Off’ and then back to Ignition position II and check that the message is no longer displayed.
1993-1999
Turn the ignition to run (one position before starting engine).
Press and hold the button located under the speedometer.
Switch ignition off and release button. Message OIL appears in the display.
Press MINUTE button of digital clock or button for setting analog clock only as long as 5 dashes appears in display.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2000-2004
Reset may be similar to previous year or other models – Oil Reset will verify and update site.
2005-2010
Manual Reset:
Turn the ignition to run (one position before starting engine).
Press and HOLD the trip-odometer button “0.0”.
Turn your key to run (one position before starting engine).
Release the trip-odometer button.
Push and release the Clock Minute Set Button “min”.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1995-2002
Turn the ignition to run (one position before starting engine).
Press and hold the button located under the speedometer.
Switch ignition off and release button. Message OIL appears in the display.
Press MINUTE button of digital clock or button for setting analog clock only as long as 5 dashes appears in display.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2007-2009
If your vehicle does not have Driver Information Center (DIC) buttons:
Turn the ignition to run (one position before starting engine).
Press the trip odometer reset stem until OIL LIFE REMAINING displays.
Press and hold the trip odometer reset stem until OIL LIFE REMAINING shows 100%. You will hear 3 chimes and the CHANGE ENGINE OIL SOON message will go off.
Turn the ignition off and then start the engine to verify the indicator has been reset.
If your vehicle has Driver Information Center (DIC) buttons:
Turn the ignition to run (one position before starting engine).
Press the vehicle information button (square) until OIL LIFE REMAINING displays.
Press and hold the set/reset button (arrow) until 100% is displayed. You will hear 3 chimes and the CHANGE ENGINE OIL SOON message will go off.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2004-2007
Turn the ignition to run (one position before starting engine).
Press and release the trip/reset button until the OIL LIFE message is displayed.
Then press and hold the trip/reset button until a chime sounds 5 times, and RESET is displayed in the message centre. When the system is reset, the odometer will again be displayed in the message centre.
Turn the ignition off and then start the engine to verify the indicator has been reset.
Designed by reset-service.com.