Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

toyota

Reset service light, maintance on Toyota Land Cruiser

1. Turn your ignition key to the ‘ACC’ or ‘LOCK’ position.
2. Press and hold the trip meter reset nob (next to your Toyota Land Cruiser’s odometer).
3. While holding the trip meter reset nob, turn the ignition to ‘ON’, but do not start your Toyota Land Cruiser.
4. Hold the meter reset until the MAINT REQD light switches off.

If this procedure does not successfully reset your maintenance required light, make sure that your digital odometer is set with the odometer reading showing and try again. If the light is still lit, you can try disconnecting your Toyota Land Cruiser battery, causing the internal computer to reset. If you still haven’t successfully turned off the oil indicator MAINT REQD light, please read your manual or contact your dealer for further instruction!

Reset service light, maintance on Toyota Rav 4

This Maintenance light is a reminder : “TIME FOR AN OIL CHANGE!”

1. Turn the ignition key to the ‘OFF’ position with the trip meter A reading shown.

2. Turn the ignition key to the ‘ON’ position while holding down the trip meter ‘RESET’ button.

3. Hold down the knob for at least 5 seconds. The odometer indicates ‘000000’ and the light goes off.

Reset service light, maintance on Toyota Avensis

How can you reset service light, maintance on Toyota Avensis

1. Set the multi-information display to TRIP A.

2. Turn the ignition switch off.

3. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG).

4. After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.

How can you reset service light, maintance on Toyota Corolla

1. Turn the ignition on without starting the engine.

2. Set the display window to ODO, TRIP.

3. Turn the ignition switch off.

4. Pressing the button PUSCH ODO TRIP reset switch turn the ignition switch to the ON position (keep pressing for at least 5 seconds).

5. Reset procedure is complete

Reset service light Toyota Yaris 2009 – 2010

1. Turn the ignition to run (one position before starting engine).

2. Ensure odometer reading is shown, turn ignition off.

3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).

4. Hold down knob for at least 5 seconds. The odometer indicates “000000″ and the light goes off. If the system fails to reset, the light will continue flashing.

5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Categories





Copyright © 2013. All Rights Reserved.