Engine should be off, hold down both buttons at the end off stork.
Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.
If it’s just the spanner flashing on the dashboard then it’s easy to reset.
Scroll through display using button on end of wiper stalk until you get to the remaining mileage.
Press and hold button until display flashes to new service mileage.
Keep button held until the spanner stops flashing and let go of button.
Turn ignition off and on to check, bingo!!
You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again
The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
Switch ignition on.
Press reset button until “spanner “ symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).
The reset button is located under the speedometer on the instrument cluster.
Switch ignition on.
Press reset button until “spanner” symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL)
With the ignition on, Press the end of the wiper stalk until miles to service appears on the dash screen.
Now, press and hold the mileage reset button on the instrument binnacle for more than 5 seconds, it will start to flash. Let go. This will reset your miles to service to the factory setting and get rid of the flashing spanner!
Press and hold the odometer reset button
Turn the ignition key to position 2
After 30 seconds release the odometer reset button
Turn ignition off
You may notice the display flashing or counting down.