BMW X5 Engine Oil Service reset
Turn the ignition to “0”
Press and hold odometer button and turn the ignition to “1”.
Hold odometer button pressed for approximately 5 seconds until the display shows: “Inspektion Re /
Release and press odometer button again until Reset flashes
Release and press odometer button shortly.
Release and press odometer button again.
The next oil service interval will be shown and will disappear.
Oil service lamp is now reset
Note: To abort the procedure at any time: turn the ignition to “0”.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.
1. switch ignition OFF,
2. press & hold trip reset stalk (instrument cluster)
3. Switch ignition ON
4. keep pressed for 10 secs,
Display will now read 0 and ‘spanner’ symbol will go out
1986-88
When “CHECK ENGINE OIL” is displayed on the Super Monitor, press the “SELECT” button below the display until “ENGINE OIL” mode is displayed (unless it already is displayed). Then press and hold the “SET” button until “OK” is displayed.
1986-1988
Turn the ignition to run (one position before starting engine).
The oil life index may be reset by pressing and holding the ENGINE DATA and GAGE buttons until Oil Index 100 message appears in the information display panel.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1989
Turn the ignition to run (one position before starting engine).
Press ENG DATA until oil life index is displayed.
Press ENG DATA and GAGE simultaneously until oil life index resets to 100.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1990
Turn the ignition to run (one position before starting engine).
Press ENG DATA until oil life index is displayed.
Press RESET/ENTER until oil life index resets to 100.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1991-1992
Without Visual Information Centre:
Turn the ignition to run (one position before starting engine).
Press OPTIONS until oil life index is displayed.
Press RESET/ENTER until oil life index resets to 100 (hold about 5 seconds).
Turn the ignition off and then start the engine to verify the indicator has been reset.
With Visual Information Centre:
Turn the ignition to run (one position before starting engine).
Press INFO key then OIL LIFE key to display oil life index.
Press RESET key until oil life index resets to 100.
Turn the ignition off and then start the engine to verify the indicator has been reset.