Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

jaguar

Reset oil service light Jaguar XF

Reset oil service light Jaguar XF. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.

How do you reset oil service light Jaguar XF.

  1. Press and hold rear fog lamp switch Ignition on, do not start engine.
  2. Release rear fog lamp switch.
  3. Press and hold trip button (end of left side stalk).
  4. Press and hold rear fog lamp switch See resetting service light message in message center.
  5. The rear fog light switch is just below the trunk release on the lower left side of the steering wheel.
  6. The message center is between the speedo and tach ,bar, not the touch screen.

 

Reset oil service light Jaguar XJ

Reset oil service light Jaguar XJ. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.

How do you reset oil service light Jaguar XJ whit diesel engine. From year: 2008.

  1. Press and hold reset button then turn ignition on.
  2. Release reset.
  3. Press and hold trip button.
  4. When holding trip button, press and hold reset button.
  5. Continue to hold both buttons for 10 seconds ( Message centre should display message like RESETTING SERVICE followed by SERVICE RESET ).

Numbers 1 to 4 need to be done within 3 seconds otherwise it will time out.

Reset the service oil light on jaguar s-type

Here’s how to do it yourself in no time works on a few different Jags….

Service Light Reset Instructions:

1 . Insert key into ignition.
2 . Press and hold the Reset switch (located on the Trip Computer Switchpack ).
3 . NOTE: The reset switch has to be released immediately after the ignition is switched ‘ON’. This is critical to enable the rest of the procedure.
Turn the key to Ignition position II and at the point of entering Ignition position II (i.e when a click is heard), instantaneously release the Reset switch.
4 . Wait one second.
5 . Press and hold the Trip switch (located on the end of the left-hand side stalk).
6 . Wait one second.
7 . Press and hold the Reset switch (whilst still holding the Trip switch).
8 . The cluster should display (within three seconds) the warning message ‘RESETTING SERVICE MODE’.
9 . Keep both buttons pressed until the warning message changes to ‘SERVICE MODE RESET’ (after ten seconds).
10 . Once the message is displayed the buttons may be released — sequence is now complete.
11 . If a Service Required message was displayed prior to the reset sequence, cycle the ignition to ‘Off’ and then back to Ignition position II and check that the message is no longer displayed.

Categories





Copyright © 2013. All Rights Reserved.