This procedure is for the Vauxhall Zafira A Service (INSP) Light Reset
With your left hand press and hold the trip reset button.
With your right hand insert key into the ignition.
Turn key to position “II” ignition lights on engine NOT started.
Keeping the trip reset button pressed you will see “INSP” and after a while “_ _ _” will be displayed.
Turn key to the “OFF” position thn release the trip reset button.
Turn key to position “II” ignition lights on engine NOT started.
That completes the service light reset for the Vauxhall Zafira A.
R P SERVICES would like to state that this process should only be used after the vehicle has been serviced.
Hot to reset service light on a Seat Inca
Try this.
Switch on the ignition.
Press the left hand button on the clocks and hold it in while switching off the ignition.
Release the button and you should be able to toggle between the oil, insp1 and insp2 indicators.
Choose the one you want to reset.
On the right hand side of the clocks there is two buttons.
Press and hold the bottom button with a biro and hold it until the display is reset.
2008
Turn the ignition key to OFF.
Press the instrument panel cluster stem until the odometer is displayed.
Press and hold the cluster stem until the letters “InSP” are displayed.
Hold the cluster stem down and turn the ignition key to RUN (one position before starting engine).
The letters “InSP” in the instrument panel cluster display will flash.
Keep the cluster stem down for at least 20 seconds and then release the stem. If the letters “InSP” and the remaining mileage for the next oil change appear in the instrument panel cluster display, the system is properly reset. Turn the ignition off and then start the engine to verify the indicator has been reset.
2009
Turn the ignition key to LOCK/OFF.
Press the instrument panel cluster stem until the odometer is displayed, then release the stem.
Re-press and hold the cluster stem until the letters “InSP” are displayed.
Press and hold the brake pedal down, hold the cluster stem down, and turn the ignition key to RUN (one position before starting engine).
The letters “InSP” in the instrument panel cluster display will flash.
Keep the cluster stem down for at least 10 seconds and release the stem and the brake pedal when the message “new remaining mileage” is displayed. Turn the ignition off and then start the engine to verify the indicator has been reset.
For oil press and hold the right hand button on the cluster – oil will appear in the display – release right hand button then turn left hand button clockwise until —– appears.
For insp prees and hold right hand button – turn on ignition – release button then press and release button again – insp will appear in the display – turn left hand button as before until —– appears.
note: if you’re clearing the insp service sometimes it’s neccessary to clear the oil service afterwards (if it wasn’t done at oil service)
Fixed service reset:
Start with key in but Ignition OFF
Press and hold both buttons on the instrument cluster
Turn Ignition ON
Keep holding both buttons until the display changes from “InSP” flashing, to “- – – -”
Release the buttons
Turn Ignition OFF
Turn Ignition back ON to confirm
Oil Service Reset:
Turn the Ignition ON (position 2) but don’t start the engine
Press and release the throttle pedal 3 times within 5 seconds
Turn Ignition OFF