Reset oil service light Jaguar XF. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.
How do you reset oil service light Jaguar XF.
Reset oil service light Jaguar XJ. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.
How do you reset oil service light Jaguar XJ whit diesel engine. From year: 2008.
Numbers 1 to 4 need to be done within 3 seconds otherwise it will time out.
Do you own a MK4 Mondeo, New Shape Transit or MK2 face lift Focus?
Do you do your own servicing or have had it serviced and still have the oil service light on?
Here are the instructions to switch off the service light:
THIS INFORMATION IS ONLY TO BE USED AFTER YOUR VEHICLE HAS BEEN SERVICED.
Turn the ignition on (engine not running but dash lights illuminated).
Turn the ignition off.
Press down both the Accelerator (Throttle) and Brake peddles.
Turn the ignition on (engine not running but dash lights illuminated).
Keep both the Accelerator (Throttle) and Brake peddles held down for between 15 and 30 seconds.
Turn off ignition.
Release peddles.
Turn the ignition on (engine not running but dash lights illuminated).
Your service light should now be out.
Think you press the trip bottom on the dash, whilst turning the ignition on, and hold it down for 10 seconds.
RESETTING 5000 MILE SERVICE LAMP ON 1994 + 1995 850
NOTE: This function is for the service reminder lamp, be sure you have performed the proper service such as changing the oil before resetting. If the check engine lamp is illuminated when the car is running, you’ll need to have the car looked at by the Volvo dealer for proper diagnosis.
1. Turn on the ignition to the KPII position so the warning lamps on the dash are illuminated. Do not start the car.
2. Open the bonnet of the car and locate Diagnostic test port (A) behind the driver side headlamp.
3. Remove the cover and pull the jumper wire out of the holder in the cover.
4. Insert the jumper into terminal #7, then press button 4 times, wait approximately 5 seconds and the red lamp should glow continuously. You are now in the data reset mode.
5. Press the button 1 time and wait approximately 5 seconds for the lamp to glow again then press the button 5 times. After about 5 seconds the lamp will illuminate again, press the button 1 time and you will see the lamp flash repeatedly for a couple of seconds indicating that the service lamp has been properly reset.
6. If a mistake is made, simply switch the ignition off and back on to reset and start over.
1996 Model (Some of them)
On these models the diagnostic socket is in front of the gear stick. Switch the ignition on. As you look at the speedometer on the dash, beneath it opposite the trip reset button is a rubber plug. Remove the plug and with a thin pointer such as a ball point pen, depress the pin. This will reset the service light.
1999 Model Service Lamp Reset Procedure
1. Press and hold trip odometer reset button
2. Turn ignition key to run position KPII (not the start position)
3. Wait 30 seconds or until service light begins blinking
4. Release Trip Odometer button
5. Turn ignition to off position