1.Switch ignition on
2.Keep pushing the button that reads ‘step’ on the centre console untill the display shows the service interval.
3.Press the reset button for 3 seconds.
Reset the service incdicator on this model as follows:
1.Swith ignition on.
2.Press the menu reset button untill the service interval is displayed.
3.Repeatedly press the Step button untill to set mileage to next service.
4.Press the C/T button untill the display changes.
5.Tap the Step button untill ‘yes’ appears.
6>press tghe C/T button then switch off ignition
2004-2005
Turn the key to position 2 in the ignition lock and immediately press the MI (MILES)button twice.
Within 10 seconds, return the key to position 0 in the ignition lock.
Press and hold the button (MI). Turn the key to position 2 in the ignition lock. Keep the button (MI) pressed.
The maintenance indicator with the current remaining time/distance is shown. After about 10 seconds, an acoustic signal will sound and the maintenance indicator is displayed with the new remaining time/distance. Release the button MI(KM).
Turn the ignition off and then start the engine to verify the indicator has been reset.
Aspen, Commander, Compass, Dakota, Grand Cherokee, Journey, Liberty, Nitro, Ram, Wrangler
2008-2010
Turn the ignition to run (one position before starting engine).
Fully depress the accelerator pedal slowly three times within 10 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2008-2010
Turn the ignition to run (one position before starting engine).
Fully depress the accelerator pedal slowly three times within 10 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.