Vehicles on fixed interval servicing can be reset as follows
Press and hold button “A” (positioned right of trip recorder display)
Switch ignition ON
The word “SERVICE” will appear in the trip recorder display
Release button “A”
Turn button “B” (positioned left of trip recorder display) to the right to reset the display
Switch ignition OFF
This applies to fixed service intervals only appearently
Button “A” is the trip reset
Button “B” is the clock set
Considering it’s made by a GM company, I would assume the standard practice here works there…
Turn key to on, but do not start…
Pump gas peddle three times…
Press and hold brake peddle till the service light blinks and then goes out…
Start the car to make sure the light was reset…
Or…
Turn to on…
Hold trip reset button…
Start car
keep holding trip reset till the light on the dash goes out…
Hopefully one of those works, but they’re just kinda the ‘try this’ until someone who knows chimes in.
Press and hold the R/H button.
Switch ignition on.
The word service will appear in the trip recorder display.
Release button.
Turn L/H button to the right to reset the display.
Switch ignition off.
Sorted!
This will not work if the vehicle is on longlife service intervals!
VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles
Sprinter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles