2009-2010
Turn the ignition to run (one position before starting engine). The maintenance information (the wrench symbol and distance to change a maintenance item) comes on for about 5 seconds and then turns off.
Push the trip computer mode switch A for 3 seconds while the wrench symbol and maintenance information are displayed. The symbol and distance display will start flashing and the display shows the current interval (ie. 5000KM).
Push the switch A to increase the interval distance. Each step increases the interval by 1000km. The interval distance can be set up to 30000km after the display returns to 0.
If no further action is made, the display returns to the previous mode and the new interval is set. If the interval distance is set to 0, the display will skip the maintenance information when the ignition is placed in run or start mode.
Tag: symbol
Reset the service counter in car (seat altea)
Switch ignition OFF
Press and hold button A (underneath rev counter)
Switch ignition ON
Release button A
A spanner symbol will be displayed
Turn button A clockwise
Switch ignition OFF
Reset Your Service Light Peugeot
If that spanner symbol has come up on your dashboard then it’s time your car was due a service. The symbol is just a periodic reminder, it doesn’t actually come up to denote a fault – the ‘check engine’ symbol does that.
If you service the car yourself and want to reset it or your garage has forgotten to reset it, you can do it yourself quite easily with the following simple steps:
This will work with the following models:
Peugeot 106 (1999 on)
Peugeot 206 (1998 on)
Peugeot 306 (1996 on)
Peugeot 307 (1996 on)
Peugeot 406 (1998 on)
Peugeot 607 (2000 on)
Peugeot 806 (1999 on)
Peugeot Expert (1999 on)
Peugeot 807 (2002 on)
Peugeot Partner (1999 on)
Peugeot Boxer (2002 on)
Procedure to Reset Peugeot Service Light as follows:
1. Switch the Ignition Off
2. Press and hold the tripmeter (mileage reset) button on the dash
3. Now switch the ignition to the ON position
4. Keep the button pressed for 10 seconds
5. The display will read ‘0’ and the service symbol will extinguish. Job done.
service light reset Audi A4
Audi A4 (2001-2007)
For Fixed Interval servicing, you can use the following procedure:
Below and to the right of the speedometer are three buttons – the right-hand button of these three is usually labelled “0,0”, and the centre button labelled with a spanner/wrench symbol.
Start with the key in, but the ignition turned OFF
Press and hold the Spanner button, while turning the ignition on (position 2)
Release the Spanner button
“SERVICE” should now appear on the display
Press and hold the 0,0 button until the display shows “SERVICE IN xxxx Miles / Kilometres”
Release the 0,0 button, then turn off the ignition
service light reset Renault Clio (2005-present), Espace 4 (2003-present), Laguna II (2001-2007), Megane II (2002-2009), Scenic II (2003-2009), Twingo (2007-present), Vel Satis (2002-2009)
The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:
Turn the Ignition ON (position 2) but do not start the engine
(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)
Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display
(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)
Press and hold the button
The display will now change to the new service interval and start flashing
Keep holding the button until the display stops flashing
Release the button