Tag: switch

Service reset for 2007 Fiat Ducato

Switch Ign on (do not start engine)
Set Odometer to read total miles.
Press Odometer Button (OB) until CFG1 appears in display
Release the OB.
Pressing the OB briefly will change between CFG1, CFG2, CFG3, CFG1
Once you have selected the CFG (see below).
Press the OB again for 5secs to store the new service frequency.
Turn off the ignition.

I selected CFG1 for my vehicle (05 Reg 2.8JTD), but you must decide yourself for your vehicle, should take 5mins to read this and carry out the resetting procedure

Note: If your vehicle is under warranty and you take it to be serviced by a Fiat dealer they will do this as part of the service.

CFG1 = 30000km (18,600mi) and 365 days in cases of Standard Use for 2.0 petrol and 2.8JTD versions, or in the case of Severe Use for the 2.3JTD versions.

CFG2 = 20000km (12,500mi) and 365 days in case of Standard Use for 2.0JTD versions, or in case of severe use for 2.0 petrol and 2.8JTD versions

CFG3 = 15000km (9,300mi) and 365 days in case of Severe Use for 2.0JTD versions

Reset service light on a Fiat Stilo

1) Ensure ignition key is turned off.

2) Press and hold the odometer reset button whilst turning the ignition switch to the on position.

3) Keep the odometer reset button pressed for 10 seconds whilst the service display counts down from 10 to 0. When the count down reaches zero the spanner icon will vanish from the display and the service indicator will be reset.

Bentley Continental Fluying Spur service display reset 2004 –

The real repair is to have the vehicle serviced by a Bentley dealer. The other option is as follows…
Press and hold the trip button
While doing this, turn the ignition key into the on position
Let go of both, and you will see the words “service reset” on the drivers instrument panel screen
Now press the silver knurled roller switch “OK” on the right side of the steering wheel controls, by the menu button. This will confirm the request.

Reset the service indicator light 2007 Renault clio

Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.

all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.

Reset Service Message Volvo S80

S80

Turn ignition switch to position I
Press and hold “day counter reset button”
Turn ignition to position II
Continue holding day counter for about 10 seconds
While SRL flashes, release day counter button
Should hear “beep-beep” to confirm command accepted