Citroen – most models
Start with the Ignition turned OFF
Press and hold the Trip Reset button on the instrument cluster
Turn the Ingition ON (position 2)
The service display should count down from 10 to 0 until reset
Release the Trip Reset and turn the Ignition OFF
The code on the mileage display when you start the car will read “IN01”, “IN02” or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):
With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure
Turn the Ignition ON (position 2) but do not start the engine
Within 100 seconds of turning the key, press the accelerator pedal to the floor and hold it down
While still holding down the accelerator, press and release the brake pedal twice, then press it a 3rd time and hold it down
Release both pedals
Within around 10 seconds, the Oil Service warning light should turn off
Immediately Turn Ignition OFF, then within 3 seconds turn it back ON (position 2)
Turn Ignition back OFF to complete
Fixed service reset:
Start with key in but Ignition OFF
Press and hold both buttons on the instrument cluster
Turn Ignition ON
Keep holding both buttons until the display changes from “InSP” flashing, to “- – – -”
Release the buttons
Turn Ignition OFF
Turn Ignition back ON to confirm
Oil Service Reset:
Turn the Ignition ON (position 2) but don’t start the engine
Press and release the throttle pedal 3 times within 5 seconds
Turn Ignition OFF
The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:
Turn the Ignition ON (position 2) but do not start the engine
(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)
Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display
(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)
Press and hold the button
The display will now change to the new service interval and start flashing
Keep holding the button until the display stops flashing
Release the button