1989-1993
Turn the ignition to run (one position before starting engine).
Press the range button until the OIL LIFE INDEX is displayed.
Press and hold the AVERAGE SPEED and RANGE buttons until the display resets to 100.
Turn the ignition to off and start engine to verify the indicator has been reset.
Tag: start
Service Oil Light Reset Nissan 370Z 2009-2010
Turn the ignition to run (push START/STOP button once).
Press the (square) button, located on the instrument panel just behind the steering wheel to the left, to display the SETTINGS mode.
In the setting mode screen press (circle) button to move to MAINTENANCE.
Set a desired interval by pushing (circle) button to highlight ENGINE OIL and pressing (square) button The reset mode will open up and allow you to enter the desired distance.
Select RESET and select new time or distance.
Repeat step 3 for ENGINE OIL FILTER. Turn the ignition off and then start the engine to verify the indicator has been reset.
How do you How do you reset the service reminder indicator light on a 2007 range rover sport?
turn off the car’s ignition.
Hold down the reset button on the dash board to zero the mileage.
keep it held in.
turn the car’s ignition on – but do not start.
keep the button in for 5 seconds.
a menu will come up – like date/mileage.
let go and then press the button again.
it will toggle through some options – then get to ‘rst’
press the button again, and your done
How to replace the rear brake pads on my passat 2007?
solved the problem, i found a TSB explaing what to do when this happens, and than i found a realy good HOW TO.
Practicly you need to reset the hand brake cylinder by:
1. Disconect batery for 5 minutes (this means if your car is 2007> you will have to go to dealer so he can put the code for radio thru some GEKO system othervise you cant use the radio!)
2. Connect the batery.
3. Dont start the car only give contact (many lights go on )
4. pres and hold the brake while presing the hand brake 2 times on and 2 times off. (i waited 30 seconds betven “on” and “off” cause the manual i found wasnt very clear)
5. Than i pussehd the cylinder back with hands, (Be carful not to turn it!!!) only push it straight i did it by hand.
6. Put everything back, deleted the fault codes and started all over again like manual said on the previous post.
I did everything like it said but at the end i end up with P on the dash light up, than i only deleted the fault codes from controler 53 – Hand brake and it worked like a charm!
How to Reset the Service Light on a Jeep
Instructions
Things You’ll Need
Wrench
Ignition key
OBDl or ll scanner
1. Disconnect your battery cables from the battery posts with a 6-pt. closed wrench in the size appropriate for the battery bolts. Remove the negative (black) cable first. Leave the battery disconnected for several minutes, according to Allpar.com. Reconnect, this time starting with the positive cable, and crank the engine. The code should be gone.
2. Crank the Jeep. Drive it forward, then backwards, and shut off. Repeat this procedure three times. The codes should clear on the fourth crank.
3. Use a OBDl or OBDll scan tool. Plug the tool into your Jeep’s ALDL (Assembly Line Diagnostic Link), a small, rectangular electrical port usually located under the dash. Turn the key to the “on” position. Scan the computer for codes and select the option to clear the codes.
4. Wait for the code to clear itself automatically. Once the component is fixed, the check engine light disappears after several successful ignitions. The code is then stored for a while. If the engine continues to start and run without a re-occurrence of the original problem, the code is wiped out.