Tag: service light reset

Service reset Sprinter 2007

Sprinter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.

When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.

Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.

1.Put on ignition

2.Wait for service mileage to revert to vehicle mileage

3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)

4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.

5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.

6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles

Reset Service Saab 9-3 and 9-5

Resetting your service indicator on Saab 9-3 and 9-5 models is easy:

1. Switch Ignition on

2. Press and release “CLEAR” button

3. Press “CLEAR” and hold down button for at least 8 seconds.

4. The word “SERVICE” will appear in the display after 2 bleeps.

5. Switch ignition off…….

Congratulations, you have now reset your service interval.

Reset Your Service Light Peugeot

If that spanner symbol has come up on your dashboard then it’s time your car was due a service. The symbol is just a periodic reminder, it doesn’t actually come up to denote a fault – the ‘check engine’ symbol does that.

If you service the car yourself and want to reset it or your garage has forgotten to reset it, you can do it yourself quite easily with the following simple steps:

This will work with the following models:

Peugeot 106 (1999 on)
Peugeot 206 (1998 on)
Peugeot 306 (1996 on)
Peugeot 307 (1996 on)
Peugeot 406 (1998 on)
Peugeot 607 (2000 on)
Peugeot 806 (1999 on)
Peugeot Expert (1999 on)
Peugeot 807 (2002 on)
Peugeot Partner (1999 on)
Peugeot Boxer (2002 on)

Procedure to Reset Peugeot Service Light as follows:

1. Switch the Ignition Off

2. Press and hold the tripmeter (mileage reset) button on the dash

3. Now switch the ignition to the ON position

4. Keep the button pressed for 10 seconds

5. The display will read ‘0’ and the service symbol will extinguish. Job done.

Toyota Tacoma reset service light

1. To reset MAINT reminder light after engine oil replacement, turn ignition switch to OFF position with odometer showing ODOMETER READING. Turn ignition switch to ON position while holding down trip meter RESET button.

2. Hold trip meter RESET button down for at least 5 seconds until odometer indicates “000000” and MAINT reminder light goes out.

How to Reset the Service Light on the Volvo S70

Put the key into the ignition and turn it to position “I.”
Press the trip odometer button in and hold it. Turn the ignition key to position “II.”
Wait about 5 seconds until the service engine light begins to blink. After the 4th blink, turn the ignition key back to position “I.”
Release the button and start the engine. The light should have turned off. If not, repeat steps 1 through 4 again.