Tag: service light reset

Skoda Octavia II (2004 – ) – 07 1.8 Service Interval Display

Page 52 of the Owner’s Manual gives the answer to this:

1. Switch off the ignition and press the reset knob of the trip counter below the speedometer and hold.

2. Switch on the ignition and release the reset button, one of the service events appear in the display.

3. It is possible to switch between the the readouts of the service events by briefly pressing the reset button.

4. When the particular service event is displayed, turn the button for setting the digital clock to the right, “service—” appears in the display.

5. Switch off the ignition. Only now is the service event reset.

Reset service light Skoda Octavia 1.9 TDi

Page 52 of the Owner’s Manual gives the answer to this:

1. Switch off the ignition and press the reset knob of the trip counter below the speedometer and hold.

2. Switch on the ignition and release the reset button, one of the service events appear in the display.

3. It is possible to switch between the the readouts of the service events by briefly pressing the reset button.

4. When the particular service event is displayed, turn the button for setting the digital clock to the right, “service—” appears in the display.

5. Switch off the ignition. Only now is the service event reset.

How do you reset the “Maintenance Required” light on 2002 Accord

1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the button.
4) After about 10-15 seconds, the light should go off.

How to Reset the Service Light on a Jeep

Instructions

Things You’ll Need
Wrench
Ignition key
OBDl or ll scanner

1. Disconnect your battery cables from the battery posts with a 6-pt. closed wrench in the size appropriate for the battery bolts. Remove the negative (black) cable first. Leave the battery disconnected for several minutes, according to Allpar.com. Reconnect, this time starting with the positive cable, and crank the engine. The code should be gone.

2. Crank the Jeep. Drive it forward, then backwards, and shut off. Repeat this procedure three times. The codes should clear on the fourth crank.

3. Use a OBDl or OBDll scan tool. Plug the tool into your Jeep’s ALDL (Assembly Line Diagnostic Link), a small, rectangular electrical port usually located under the dash. Turn the key to the “on” position. Scan the computer for codes and select the option to clear the codes.

4. Wait for the code to clear itself automatically. Once the component is fixed, the check engine light disappears after several successful ignitions. The code is then stored for a while. If the engine continues to start and run without a re-occurrence of the original problem, the code is wiped out.

Chevrolet Cobalt 2004-2010 Oil Service Light Reset

2005-2010

Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.