Press and hold the R/H button.
Switch ignition on.
The word service will appear in the trip recorder display.
Release button.
Turn L/H button to the right to reset the display.
Switch ignition off.
Sorted!
This will not work if the vehicle is on longlife service intervals!
Tag: Reset Maintenance Light
Reset service notification on display at vw sharan 2001
with the ignition off
press and hold the miles reset button in on dash
now turn on ignition and start engine
‘service now’ should now be displayed
now turn the clock adjuster button either left or right and this should rest the service
noification.
Reset Service Light on a Polo 96-99
Polo 96-99
IN01 -inspection service
Switch ignition ON
Press and hold button (A left) under speedo
Switch ignition OFF
Release button
Press and release button A (left)
The letter “IN01” will appear in the odometer display of the speedometer.
Press clock minute button B until “—–” appears in the display
Press button A (left) to display “OEL”
Press button B to display “—–”
Switch ignition on until the letters “IN00” appear in the display
I have instructions for Oil service (OEL) and IN02 inspection service if this doesn’t work.
Service reset VW Crafter 2.5 td
VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles
Reset Your Service Light Peugeot
If that spanner symbol has come up on your dashboard then it’s time your car was due a service. The symbol is just a periodic reminder, it doesn’t actually come up to denote a fault – the ‘check engine’ symbol does that.
If you service the car yourself and want to reset it or your garage has forgotten to reset it, you can do it yourself quite easily with the following simple steps:
This will work with the following models:
Peugeot 106 (1999 on)
Peugeot 206 (1998 on)
Peugeot 306 (1996 on)
Peugeot 307 (1996 on)
Peugeot 406 (1998 on)
Peugeot 607 (2000 on)
Peugeot 806 (1999 on)
Peugeot Expert (1999 on)
Peugeot 807 (2002 on)
Peugeot Partner (1999 on)
Peugeot Boxer (2002 on)
Procedure to Reset Peugeot Service Light as follows:
1. Switch the Ignition Off
2. Press and hold the tripmeter (mileage reset) button on the dash
3. Now switch the ignition to the ON position
4. Keep the button pressed for 10 seconds
5. The display will read ‘0’ and the service symbol will extinguish. Job done.