How to replace the rear brake pads on my passat 2007?

solved the problem, i found a TSB explaing what to do when this happens, and than i found a realy good HOW TO.

Practicly you need to reset the hand brake cylinder by:

1. Disconect batery for 5 minutes (this means if your car is 2007> you will have to go to dealer so he can put the code for radio thru some GEKO system othervise you cant use the radio!)

2. Connect the batery.

3. Dont start the car only give contact (many lights go on )

4. pres and hold the brake while presing the hand brake 2 times on and 2 times off. (i waited 30 seconds betven “on” and “off” cause the manual i found wasnt very clear)

5. Than i pussehd the cylinder back with hands, (Be carful not to turn it!!!) only push it straight i did it by hand.

6. Put everything back, deleted the fault codes and started all over again like manual said on the previous post.

I did everything like it said but at the end i end up with P on the dash light up, than i only deleted the fault codes from controler 53 – Hand brake and it worked like a charm!

Reset the service counter in car (seat altea)

Switch ignition OFF
Press and hold button A (underneath rev counter)
Switch ignition ON
Release button A
A spanner symbol will be displayed
Turn button A clockwise
Switch ignition OFF

Reset service light 2007 seat leon

Service light reset is as follows:-

1. Press and Hold the Odometer knob in
2. Turn the ignition on (do not start the car though)
3. Turn the odometer knob to the right and hold for about 5 secs.
4. Release odometer knob and switch ignition off.
5. Start car, Service indicator should now be gone.== Answer ==
cheers for the info worked first time probably saved me a few quid putting the car to a dealers.
ta much!

this worked on a 2000 modal with out a problem

Reset the service light on opel / vauxhall signum 04

Considering it’s made by a GM company, I would assume the standard practice here works there…

Turn key to on, but do not start…
Pump gas peddle three times…
Press and hold brake peddle till the service light blinks and then goes out…
Start the car to make sure the light was reset…

Or…

Turn to on…
Hold trip reset button…
Start car
keep holding trip reset till the light on the dash goes out…

Hopefully one of those works, but they’re just kinda the ‘try this’ until someone who knows chimes in.

Reset service light toyota yaris

I second that, as I was shown how to do it. Follow it, VEry simple instructions.

Have your key in the ignition, but off. Well make sure its at trip A before you start this.

Next, press the button, but leave it pressed….
Now put the car into the “on” position….
The indicator will show a bar like it was counting down, wait till that finishes and it all starts to show 0000miles or whatever it is. And let go.

Your done.