To reset the oil change indicator system (after
performing the scheduled maintenance), refer to the
following procedure:
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
1. Put the key in the ignition and switch it on without starting the engine.
(Wait for LCD to return to the vehicle mileage)
2. Hold the “O” button down till you hear a beep (could take a while, 30 sec.)
3. Press the M button repeatedly and a number of reset menus will appear, (If you have used oil according to quality sheet 229.31 or 228/229.51 you can scroll to Reset.31 or Reset.51 respectively.) Select “reset 51”
4. Now, when appropriate oil type is selected press “O” for 6 seconds until ”2” is displayed.
5. Press “O” once again briefly and the ” reset done” message will confirm that the job is done.
6. Pull the Key out
FOR THE 2004 DODGE SPRINTER!
Turn the key to position 2 in the ignition lock and immediately press the button MI (km) twice.
Within 10 seconds, return the key to the 0 in the ignition lock.
Press and hold the button MI (km). Turn the key to position 2 in the ignition lock. Keep the button MI (km) pressed.
The maintenance indicator with the time/distance is shown.
After about 10 seconds, an acoustic signal will sound and the maintenance indicator is displayed with the new remaining time / distance .
Release the button MI (km)
With the ignition key off, press and hold the trip button
while doing this, turn the ignition key to the on position
The driver’s instrument panel screen will now read “service reset.”
Now press the silver knurled knob on the right side of the steering wheel controls, this will confirm the operation.
To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.
NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.
The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.
Engine should be off, hold down both buttons at the end off stork.
Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.
If it’s just the spanner flashing on the dashboard then it’s easy to reset.
Scroll through display using button on end of wiper stalk until you get to the remaining mileage.
Press and hold button until display flashes to new service mileage.
Keep button held until the spanner stops flashing and let go of button.
Turn ignition off and on to check, bingo!!
You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again