Tag: light

Turn Off an Oil Light on a 2005 KIA Spectra

Instructions

1. Pull the vehicle over to a safe area, if the light comes on while driving. If you are very close to a store that sells motor oil, stop there. Do not continue driving with the indicator light lit, as severe engine damage may occur.

2. Turn off the vehicle’s engine and open the hood. Locate the oil filler cap and oil dipstick on the top-front of the engine.

3. Check the engine oil level on the oil dipstick. If the engine oil is low, remove the oil cap and add oil until the oil level on the oil dipstick reaches the “Full” mark.

4. Replace the oil cap and restart the Kia. The oil light should turn off within a few seconds of starting the vehicle.

Reset oil service KIA forte 2010 oil mantainance light

u can change the oil after every 5000 miles

Reset the Range Rover Airbag Fault Code

Instructions

1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.

2. Slide the clamp off of the negative battery terminal.

3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.

4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

Rover 75 Reset Oil Service Light

Well after a small but required service on the car I had to reset the warning light. The real quick deal to reset all the requested lights on Rover 75 is to do the following

Get a small wire, Turn the key to second position, Short Pin 8 and Pin 4 on the OBD connector for “4 seconds to reset oil light”, “8-25 seconds for the other 2 lights” and this will reset the 15000 service request for oil change. Quick and easy and not legal if you do it without actually doing the service.

Reset the service light on a 2002 Rover 75

There are 3 stages
locate the obd plug and find pin 8 then
turn ignition to pos 2
with a fused wire ( a piece of wire with a fuse in it)
ground pin 8 for 4-5 seconds
turn ignition off
repeat this procedure 2 more times but for 8-12 seconds and then the service indicator will be reset.