Tag: indicator

Reset service light, maintance on Toyota Land Cruiser

1. Turn your ignition key to the ‘ACC’ or ‘LOCK’ position.
2. Press and hold the trip meter reset nob (next to your Toyota Land Cruiser’s odometer).
3. While holding the trip meter reset nob, turn the ignition to ‘ON’, but do not start your Toyota Land Cruiser.
4. Hold the meter reset until the MAINT REQD light switches off.

If this procedure does not successfully reset your maintenance required light, make sure that your digital odometer is set with the odometer reading showing and try again. If the light is still lit, you can try disconnecting your Toyota Land Cruiser battery, causing the internal computer to reset. If you still haven’t successfully turned off the oil indicator MAINT REQD light, please read your manual or contact your dealer for further instruction!

Reset service light Toyota Yaris 2009 – 2010

1. Turn the ignition to run (one position before starting engine).

2. Ensure odometer reading is shown, turn ignition off.

3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).

4. Hold down knob for at least 5 seconds. The odometer indicates “000000″ and the light goes off. If the system fails to reset, the light will continue flashing.

5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Reset service indicator / interval on this model as follows Chrysler Grand Cherokee 1995 , 1996 , 1997 , 1998 , 1999 , 2000 , 2002 , 2003 , 2004 , 2005 .

1.Switch ignition on

2.Keep pushing the button that reads ‘step’ on the centre console untill the display shows the service interval.

3.Press the reset button for 3 seconds.

Reset service indicator Chrysler Voyager 2001 , 2002 , 2003 , 2004 , 2005 , 2006 , 2007 , 2008

Reset the service incdicator on this model as follows:

1.Swith ignition on.

2.Press the menu reset button untill the service interval is displayed.

3.Repeatedly press the Step button untill to set mileage to next service.

4.Press the C/T button untill the display changes.

5.Tap the Step button untill ‘yes’ appears.

6>press tghe C/T button then switch off ignition

Service light indicator reset Scudo

Think you press the trip bottom on the dash, whilst turning the ignition on, and hold it down for 10 seconds.