2005-2010
Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1. Make sure the light is has a wrench icon. This article is not intended to help reset a “service engine” light.
2. Without turning on your car, turn the key to the right and you’ll see all of your dash lights come on.
3. Press on the brake 4 times. On the 4th time, hold the brake petal down for 30 seconds and release. This should reset the light.
4. Always always always contact your mechanic! This trick was told to me by my mechanic because I saw the light and took it in for servicing. I went to a non-dealer mechanic, but after they ran a diagnostic, they couldn’t find anything wrong. I called my GM mechanic and they suggested that if noting was found wrong, it was probably a light that needed to be reset. I plan to take it in for a tune-up soon but knowing that nothing serious was wrong was a nice weight off my shoulders and my wallet!
1. Pull the hood release to open the hood. Prop it up with a rod and locate the battery under the hood.
2. Find the negative battery terminal. You will see a clamp with a nut on it. Loosen the nut with an adjustable wrench and slid the clamp off of the battery terminal.
3. Wrap a towel around the negative battery clamp and keep it away from the battery altogether. The towel will help to protect you and the battery.
4. Let the vehicle sit for about 15 minutes. This will allow the computer to reset and erase all trouble codes.
5. Discard the towel and put the negative battery clamp back onto the negative battery terminal. Tighten the nut with the wrench. Tuck the rod away and lower the hood of the car.
6. Put the key into the ignition and start the engine. Verify that all service and warning lights have turned off.
with the ignition off
press and hold the miles reset button in on dash
now turn on ignition and start engine
‘service now’ should now be displayed
now turn the clock adjuster button either left or right and this should rest the service
noification.
First you press the odometer button then at the same time you put the key in “on” no engine running, wait for 30 secs aprox and it will be reset, repeat this steps for the oil light
what is the odometer button