Tag: display

service light reset BMW 2001

BMW 2001 to current

Ignition Off (Position 0)
Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
Keep the button depressed (about 5 secs.) until you see “Oil Service” or “Inspection” with “Reset” or “Re” in the display*
Press the button again and hold for approx. 5 secs. until “Reset” or “Re” flashes
While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see “END SIA” for about 2 seconds
Note: that if the “Reset” or “Re” does not flash, then you have not met the minimum consumption level and cannot reset

*Note: On vehicles with “High” cluster, you will also see the amount of fuel (in litres) remaining until next service

service light reset Citroen

Citroen – most models

Start with the Ignition turned OFF
Press and hold the Trip Reset button on the instrument cluster
Turn the Ingition ON (position 2)
The service display should count down from 10 to 0 until reset
Release the Trip Reset and turn the Ignition OFF

service light reset Volkswagen (with digital Odomoter)

The code on the mileage display when you start the car will read “IN01”, “IN02” or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):

With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure

service light reset Opel / Vauxhall Agila B (2008 onwards)

Fixed service reset:

Start with key in but Ignition OFF
Press and hold both buttons on the instrument cluster
Turn Ignition ON
Keep holding both buttons until the display changes from “InSP” flashing, to “- – – -”
Release the buttons
Turn Ignition OFF
Turn Ignition back ON to confirm
Oil Service Reset:

Turn the Ignition ON (position 2) but don’t start the engine
Press and release the throttle pedal 3 times within 5 seconds
Turn Ignition OFF

service light reset Ford Galaxy

With the ignition off, press the reset button under the mileage counter
Hold in reset button whilst turning the ignition on
After about 4 or 5 seconds (up to 30 seconds in some cases) the display should reset itself
Release the button and turn the ignition off
It may be necessary to repeat this process