Tag: cluster

Service light reset BMW 1 Series

2008-2012

BMW recommends the use of a reset tool.

Manual Reset

1. Turn ignition to Terminal 15 which is one turn of the key or one press of the START/STOP button.
2. Press and hold the Instrument Cluster Set/Reset button for 10 seconds.
3. The upper display in the Instrument Cluster will be illuminated with a Service Item. The lower display in the Instrument Cluster will indicate the remaining time or mileage left for that Service Item. Pressing the button repeatedly will allow the display to scroll through all of the Condition Based Service Items.
4. Press and hold the Instrument Cluster Set/Reset button again and the lower display screen will indicate “”OK”” or “”DUE””.”
5. Pressing the Instrument Cluster Set/Reset button again will allow the “”RESET”” to appear in the lower window for that service. Releasing and reapplying the button one more time will reset the service displayed in the upper window only.
6. Turn the ignition off and start the engine to verify the indicator has been reset.

Service Light Reset – Renault Safrane

The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.

Switch ignition on.

Press reset button until “spanner “ symbol flashes.

Keep button depressed until “spanner” symbol stops flashing and remains illuminated.

Indicator shows appropriate service interval.

Release reset button.

Switch ignition off.

Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).

Service Light Reset – Renault Laguna

The reset button is located under the speedometer on the instrument cluster.

Switch ignition on.

Press reset button until “spanner” symbol flashes.

Keep button depressed until “spanner” symbol stops flashing and remains illuminated.

Indicator shows appropriate service interval.

Release reset button.

Switch ignition off.

Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL)

Removal of spanner from peugeot 307 SW without going to garage

1. switch ignition OFF,
2. press & hold trip reset stalk (instrument cluster)
3. Switch ignition ON
4. keep pressed for 10 secs,

Display will now read 0 and ‘spanner’ symbol will go out

Reset the service oil light on jaguar s-type

Here’s how to do it yourself in no time works on a few different Jags….

Service Light Reset Instructions:

1 . Insert key into ignition.
2 . Press and hold the Reset switch (located on the Trip Computer Switchpack ).
3 . NOTE: The reset switch has to be released immediately after the ignition is switched ‘ON’. This is critical to enable the rest of the procedure.
Turn the key to Ignition position II and at the point of entering Ignition position II (i.e when a click is heard), instantaneously release the Reset switch.
4 . Wait one second.
5 . Press and hold the Trip switch (located on the end of the left-hand side stalk).
6 . Wait one second.
7 . Press and hold the Reset switch (whilst still holding the Trip switch).
8 . The cluster should display (within three seconds) the warning message ‘RESETTING SERVICE MODE’.
9 . Keep both buttons pressed until the warning message changes to ‘SERVICE MODE RESET’ (after ten seconds).
10 . Once the message is displayed the buttons may be released — sequence is now complete.
11 . If a Service Required message was displayed prior to the reset sequence, cycle the ignition to ‘Off’ and then back to Ignition position II and check that the message is no longer displayed.