Audi A3 (2003-2009)
For Fixed Interval servicing, you can use the following procedure:
Start with the ignition turned ON (position 2), but with the engine OFF
Pull out and hold the button on the right side of the display until “SERVICE” appears on the display
Release the button on the right, then within 5 seconds pull the button out and hold it again
Release the button when the display shows “- – -” or “SERVICE IN xxxx Miles / Kilometres, xxxx days”
Turn off the ignition
Audi A4 (2001-2007)
For Fixed Interval servicing, you can use the following procedure:
Below and to the right of the speedometer are three buttons – the right-hand button of these three is usually labelled “0,0”, and the centre button labelled with a spanner/wrench symbol.
Start with the key in, but the ignition turned OFF
Press and hold the Spanner button, while turning the ignition on (position 2)
Release the Spanner button
“SERVICE” should now appear on the display
Press and hold the 0,0 button until the display shows “SERVICE IN xxxx Miles / Kilometres”
Release the 0,0 button, then turn off the ignition
For Fixed Interval servicing, you can use the following procedure:
Start with the key in, but the ignition turned OFF
Press and hold the button on the right of the display, while turning the ignition one click (to position 1)
Release the button on the right
“SERVICE” should now appear on the display
Press and hold the button on the left of the display until it shows “SERVICE IN xxxx Miles / Kilometres”
Release the left button, then turn off the ignition
BMW 2001 to current
Ignition Off (Position 0)
Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
Keep the button depressed (about 5 secs.) until you see “Oil Service” or “Inspection” with “Reset” or “Re” in the display*
Press the button again and hold for approx. 5 secs. until “Reset” or “Re” flashes
While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see “END SIA” for about 2 seconds
Note: that if the “Reset” or “Re” does not flash, then you have not met the minimum consumption level and cannot reset
*Note: On vehicles with “High” cluster, you will also see the amount of fuel (in litres) remaining until next service
The code on the mileage display when you start the car will read “IN01”, “IN02” or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):
With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure