Reset oil service, maintenance light reset, oilreset

Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

Reset oil service SCION iQ 2012

2012

1. Turn the ignition to run (one position before starting engine).
2. Select trip metre A reading by using the trip metre button and then turn the ignition off.
“3. While pressing the trip meter reset button
4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Reset oil service light Jaguar XF

Reset oil service light Jaguar XF. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.

How do you reset oil service light Jaguar XF.

  1. Press and hold rear fog lamp switch Ignition on, do not start engine.
  2. Release rear fog lamp switch.
  3. Press and hold trip button (end of left side stalk).
  4. Press and hold rear fog lamp switch See resetting service light message in message center.
  5. The rear fog light switch is just below the trunk release on the lower left side of the steering wheel.
  6. The message center is between the speedo and tach ,bar, not the touch screen.

 

Reset oil service light Jaguar XJ

Reset oil service light Jaguar XJ. How to reset maintenance light, reset service light indicator. Can be made manually by use button on car dash board.

How do you reset oil service light Jaguar XJ whit diesel engine. From year: 2008.

  1. Press and hold reset button then turn ignition on.
  2. Release reset.
  3. Press and hold trip button.
  4. When holding trip button, press and hold reset button.
  5. Continue to hold both buttons for 10 seconds ( Message centre should display message like RESETTING SERVICE followed by SERVICE RESET ).

Numbers 1 to 4 need to be done within 3 seconds otherwise it will time out.

Reset oil service light Ford Explorer Sport Trac

Reset oil service light Ford Explorer Sport Trac. From years: 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010.

How do you reset oil service light Ford Explorer Sport Trac. From years:1999, 2000, 2001.

  1. Turn the ignition to run, one position before starting engine.
  2. Press and hold the OIL CHANGE RESET control for 5 seconds. The message centre will count down for 5 seconds and the message centre will display OIL LIFE RESET TO 100%.
  3. Turn the ignition off and then start the engine to verify the indicator has been reset.

 

How to reset oil service light Ford Explorer Sport Trac. From years: 2002, 2003.

  1. Turn the ignition to run , ne position before starting engine.
  2. Press the SETUP control to access the System Check function.
  3. Press and release the RESET control to display OIL LIFE XX% HOLD RESET NEW.
  4. Press and hold the RESET control for 2 seconds to display IF NEW OIL HOLD RESET.
  5. Press and hold the RESET control to display OIL LIFE SET TO 100%. Your oil life is now reset.
  6. Turn the ignition off and then start the engine to verify the indicator has been reset.

 

Full procedure how to reset oil service light Ford Explorer Sport Trac. From years: 2004, 2005.

  1. Turn the ignition to run, one position before starting engine.
  2. Select this function from the SETUP control PRESS RESET AT OIL CHANGE.
  3. Press RESET control to reset oil change.
  4. Turn the ignition off and then start the engine to verify the indicator has been reset.

 

How can you reset oil service light Ford Explorer Sport Trac. From years: 2006, 2007.

To reset the oil monitoring system to 100% after each oil change Ford Explorer Sport Trac. From years: 2006, 2007 [approximately 5,000 miles (8,000 km) or 180 days] perform the following.

  1. Turn the ignition to run, one position before starting engine.
  2. Enter SYSTEM CHECK to display “OIL XXX% OIL LIFE OK”.
  3. Press RESET control to display “HOLD RESET IF NEW OIL”.
  4. Press and hold the RESET control for more than 2 seconds. Oil life is set to 100% and “OIL CHANGE SET TO 100%” is displayed.

Note: To change oil life 100% miles value from 5,000 miles (8,000 km) or 180 days to another value, refer to the Oil Life Start Value selected from the SETUP MENU in this section.

Reset Oil life Start Value Ford Explorer Sport Trac. From years: 2006, 2007.

  1. Select this function from the SETUP control for the current display mode.
  2. Each press of the RESET control reduces the value by 10 percent.

Note: Oil Life Start Value of 100% equals 5,000 miles (8,000 km) or 180 days. For example, setting Oil Life Start Value to 60% sets the Oil Life Start Value to 3,000 miles (4,828 km) and 120 days.

 

 

How do you reset oil service light Ford Explorer Sport Trac. From years:2008, 2009, 2010.

To reset the oil monitoring system to 100% after each oil change Ford Explorer Sport Trac. From years: 2008, 2009, 2010 [approximately 7,500 miles (12,070 km) or 6 months] perform the following.

  1. Turn the ignition to run, one position before starting engine.
  2. Press RESET control to display “HOLD RESET IF NEW OIL”.
  3. Press and hold the RESET control for more than 2 seconds. Oil life is set to 100% and “OIL CHANGE SET TO 100%” is displayed.
  4. Note: To change oil life 100% miles value from 7,500 miles (12,070 km) or 6 months to another value, proceed to step 5.
  5. Once “OIL LIFE SET TO XXX%” is displayed, release and press the RESET control switch to change the Oil Life Start Value. Each release and press will reduce the value by 10 percent.
  6. Note: Oil Life Start Value of 100% equals 7,500 miles (12,070 km) or 6 months. For example, setting Oil Life Start Value to 60% sets the Oil Life Start Value to 3,000 miles (4,828 km) and 120 days.

OIL CHANGE REQUIRED. Displayed when the engine oil life remaining is 0%.

An oil change is required whenever indicated by the message center and according to the recommended maintenance schedule.

ENGINE OIL CHANGE SOON. Displayed when the engine oil life reaches 5% or less of the Oil Life Start Value.

Reset oil service light Ford E 150 Series

Reset oil service light Ford E 150 Series. From years: 2009, 2010, 2011, 2012.

How to reset oil service light Ford E 150 Series.

Oil Life Reset and Start Value.  An oil change is required whenever indicated by the message center and according to the recommended maintenance schedule.

To reset the oil monitoring system to 100% after each oil change Ford E 150 Series. From years: 2009, 2010, 2011, 2012 (approximately 7,500 miles [12,000 km] or six months) perform the following.

  1. Switch the ignition ON, do not start the engine.
  2. Press and release the SELECT/RESET stem to display “OIL LIFE = XXX% HOLD RESET = NEW”.
  3. Press and hold the SELECT/RESET stem for two seconds and release. Oil life is set to XX% and “OIL LIFE SET TO XXX%” is displayed.
  4. To change oil life 100% miles value from 7,500 miles (12,000 km) or six months to another value, proceed to Step 5.
  5. Once “OIL LIFE SET TO XXX%” is displayed, release and press the RESET control switch to change the Oil Life Start Value. Each release and press will reduce the value by 10%.

Note: Oil Life Start Value of 100% equals 7,500 miles (12,000 km) or six months. For example, setting Oil Life Start Value to 60% sets the Oil Life Start Value to 3,000 miles (4,800 km) and 120 days.

OIL LIFE CHANGE SOON. Displayed when the engine oil life remaining is 5% or less. When oil life left is between 5% and 0%, the ENGINE OIL CHANGE SOON message will be displayed.

OIL CHANGE REQUIRED. Displayed when the oil life left reaches 0%, the OIL CHANGE REQUIRED message will be displayed. OIL LIFE OK displays after you have changed the oil.

Categories

Recent Comments





Copyright © 2013. All Rights Reserved.

Designed by reset-service.com.