To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.
NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.
The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.
Engine should be off, hold down both buttons at the end off stork.
Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.
If it’s just the spanner flashing on the dashboard then it’s easy to reset.
Scroll through display using button on end of wiper stalk until you get to the remaining mileage.
Press and hold button until display flashes to new service mileage.
Keep button held until the spanner stops flashing and let go of button.
Turn ignition off and on to check, bingo!!
You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again
The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
Switch ignition on.
Press reset button until “spanner “ symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).
The reset button is located under the speedometer on the instrument cluster.
Switch ignition on.
Press reset button until “spanner” symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL)
Recent Comments