2001-2005
Manual Reset using DIS and Reset Knobs:
1. Turn off the ignition
2. Locate the Driver Information System (DIS) in the instrument panel.
3. Locate the reset buttons (WRENCH button and 0
4. Do the following to display the SERVICE! Message in the DIS:
i) Press and hold the Wrench button.
ii) Turn on the ignition – do not start the engine.
iii) Release the WRENCH button.
5. Do the following to display the next service interval (SERVICE in ##MI)
i) Press and hold the 0
ii) Release the 0
6. Turn off the ignition.
7. Start the engine and verify indicator has been reset.
Manual Reset using DIS and Reset Knobs:
1. Turn off the ignition
2. Locate the Driver Information System (DIS) in the instrument panel.
3. Do the following to display the SERVICE! message in the display.
i) Press and hold the right RESET knob.
ii) Turn on the ignition – do not start the engine.
iii) Release the knob.
4. Do the following to display the next service interval (SERVICE IN ##MI)
i) Press and hold the right RESET knob.
ii) Release the knob.
5. Turn off the ignition.
6. Start the engine and verify indicator has been reset.
The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:
Turn the Ignition ON (position 2) but do not start the engine
(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)
Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display
(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)
Press and hold the button
The display will now change to the new service interval and start flashing
Keep holding the button until the display stops flashing
Release the button
1997-1999
Manual Reset:
Turn key in steering lock to position 2.
Within 4 seconds press button (1) left of speedometer twice.
The present status for days or distance displays, within 10 seconds turn key in steering lock to position O.
Press and hold button (1), while turning key in steering lock to position 2 again. The present status for days or distance displays once more.
Continue to hold button (1) for approximately 10 seconds until a signal sounds and the display shows 10 000 mils or 15 000km. Release button (1).
2000-2002
Manual Reset:
Switch ignition on and immediately press knob to left of speedometer twice within 4 seconds.
Present status for days or distance is now displayed. Within 10 seconds, turn key in steering wheel lock to position 0.
Press and hold button to the left of speedometer, while turning key in steering lock to position 2 again. The present status for days or distance is displayed again. Continue to hold button until you hear a signal (approximately 10 seconds).
Release button.
Service interval displays the reset interval.
2003
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator with (Single Wrench) or (Double Wrench) and the service deadline appears in the multifunction display.
Press the reset knob for about 4 seconds. This message appears in the tachometer: “DO YOU WANT TO RESET SERVICE INTERVAL? CONFIRM BY USING RESET BUTTON”.
To confirm hold down the reset button until you hear a signal. The service indicator now displays the reset interval.
2004
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator with (Single Wrench) or (Double Wrench) and the service deadline appears in the multifunction display.
Press the reset knob for about 4 seconds. This message appears in the tachometer: “SERVICE INTERVAL…RESET: R-BUTTON 3 SEC.”
To confirm hold down the reset button until you hear a signal. The service indicator now displays the reset interval.
1997-1999
*Diagnostic Reset Tool Required
Turn key in steering lock to position 2.
Within 4 seconds press button (1) left of speedometer twice.
The present status for days or distance displays, within 10 seconds turn key in steering lock to position 0.
Press and hold button (1), while turning key in steering lock to position 2 again. The present status for days or distance displays once more.
Continue to hold button (1) for approximately 10 seconds until a signal sounds and the display shows 10 000 mils or 15 000km. Release button (1).
2000-2004
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator with (Single Wrench) or (Double Wrench) and the service deadline appears in the multifunction display.
Press the reset knob to the right in the instrument cluster for about 2 seconds. This message appears in the multifunction display: “SERVICE INTERVAL? RESET WITH R BUTTON”.
To confirm hold down the reset button until you hear a signal. The service indicator now displays the reset interval.
1997-1999
*Diagnostic Reset Tool Required (please refer to TOOLS page)
Manual Reset:
Turn key in steering lock to position 2.
Within 4 seconds press 0 button twice.
The present status for days or distance displays, within 10 seconds turn the electroninc key in steering lock to position 0.
Press and hold 0 button while turning electronic key in steering loack to position 2 again. The present status for days or distance displays once more. Continue to hold 0 button for approximately 10 seconds until a signal sounds and the display shows 10 000 (15000KM) for approximately 10 seconds.
Release 0 button, the status is reset.
2000-2003
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator with (Single Wrench) or (Double Wrench) and the service deadline appears in the multifunction display.
Press the reset knob to the left in the instrument cluster for about 4 seconds. This message appears in the multifunction display: “DO YOU WANT TO RESET SERVICE INTERVAL? TO CONFIRM PRESS BUTTON”.
To confirm hold down the reset button until you hear a signal. The service indicator now displays the reset interval.
2004
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator with (Single Wrench) or (Double Wrench) and the service deadline appears in the multifunction display.
Press the reset knob to the left in the instrument cluster for about 4 seconds. This message appears in the multifunction display: “SERVICE INTERVAL…TO RESET: PRESS RESET BUTTON FOR 3 SECONDS”.
To confirm hold down the reset button until you hear a signal. The service indicator now displays the reset interval.