Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

warning

Service oil reset Lexus GS – Series

2006
Turn the ignition to run (one position before starting engine).
Push the ěODO TRIPî switch to change the display to blank. Turn the ignition off.
While pressing the trip meter reset button, set the engine switch to run (one position before starting engine).
Keep pushing the ěRESETî switch for more than 7 seconds. While doing this operation, the master warning light comes on, a warning tone sounds and the “OIL MAINT RESET” message appears to inform you that light has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2007
Turn the ignition to run (one position before starting engine).
Press the ěDISPî switch to change the multi-information display to blank. Turn the ignition off.
While pressing the trip meter reset button, set the engine switch to run (one position before starting engine).
Keep pushing the ěRESETî switch for more than 7 seconds. While doing this operation, the master warning light comes on, a warning tone sounds and the “OIL MILEAGE RESET” message appears to inform you that light has been reset. After 5 seconds, the system reset is completed.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2008-2010
Turn the ignition to run – engine off (push START/STOP button once).
Press the ěDISPî switch to change the multi-information display to blank. Turn the ignition off.
While pressing the trip meter reset button, set the engine switch to run – engine off (push START/STOP button once).
Keep pushing the ěRESETî switch for more than 7 seconds. While doing this operation, the master warning light comes on, a warning tone sounds and the “OIL MESSAGE RESET” message appears to inform you that light has been reset. After 5 seconds, the system reset is completed.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Reset the On-Board Computer for a 2003 Ford Fiesta

1. Pull the hood release to open the hood. Prop it up with a rod and locate the battery under the hood.

2. Find the negative battery terminal. You will see a clamp with a nut on it. Loosen the nut with an adjustable wrench and slid the clamp off of the battery terminal.

3. Wrap a towel around the negative battery clamp and keep it away from the battery altogether. The towel will help to protect you and the battery.

4. Let the vehicle sit for about 15 minutes. This will allow the computer to reset and erase all trouble codes.

5. Discard the towel and put the negative battery clamp back onto the negative battery terminal. Tighten the nut with the wrench. Tuck the rod away and lower the hood of the car.

6. Put the key into the ignition and start the engine. Verify that all service and warning lights have turned off.

service light reset Volkswagen (with digital Odomoter)

The code on the mileage display when you start the car will read “IN01”, “IN02” or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):

With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure

Categories





Copyright © 2013. All Rights Reserved.