Volvo 1999-2000 – S / V / C70 Models
Press and Hold odometer reset button
Turn ignition switch to “run” position
After SRL flashes, release odometer reset button
Turn ignition off
Turn ignition back on to confirm reset
Volvo 1998 – S80 Models
Turn ignition switch to position 1
Press and hold the odometer reset button
Turn ignition switch to position 2
Wait until service light blinks and then release odometer button
Volvo 1999-2000 – S80 Models
Turn ignition switch to position 1
Press and hold “day counter reset button”
Turn ignition switch to position 2
Continue holding day counter for approx. 10 seconds
After SRL flashes, release day counter button
Should hear “beep-beep” to confirm command accepted
Volvo 2001 – XC 70 Models
The following steps must be completed with no longer than 5 seconds between each step:
Make sure the trip meter is in T-1
Turn ignition key to position 1
Press and hold trip meter button until zero is shown
While still holding the trip meter, turn key to position 2
When original trip mileage returns, release the trip reset button
Turn key to off
The code on the mileage display when you start the car will read “IN01”, “IN02” or similar. To remove this, use the following procedure (this should work on any VW with a digital odometer):
With the key out of the ignition find and press the odometer reset button (hold down)
Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button)
Turn ignition off (button still pressed) and remove the key
Release reset button
Interval should now be reset. If this is not the case, repeat the above procedure
The service light on these vehicles is usually a spanner / wrench symbol. To reset that indicator:
Turn the Ignition ON (position 2) but do not start the engine
(On cars with keycard ignition, insert the card, then press and hold the start button for 5 seconds to turn on the dash cluster)
Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display
(Some models have 2 buttons, which cycle through the options in opposite directions – either button can be used in this case)
Press and hold the button
The display will now change to the new service interval and start flashing
Keep holding the button until the display stops flashing
Release the button