Reset service light indicator Renault Modus. From year: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How to reset service light indicator Renault Modus.
1. To reset the mileage before service on a Renault Modus, follow this steps.
2. Select the miles/km to service display on the trip computer.
3.Repeatedly push and hold one of the two buttons on the end of the windscreen wiper stalk for about 10 seconds until the mileage is reset and the display shows the mileage before maintenance service permanently.
To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.
NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.
The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.
The procedure for the Mégane II (2002-2006, pre-facelift model) is:
Scroll through the trip computer until you get to the “change oil soon message/miles to next service” displayed.
Press and hold the mileage trip reset button on the speedo untill the display flashes, and then stays fixed. This can take a few seconds.
If you mean the spanner symbol & message such as ‘change oil soon’ just scroll through your trip computer as you do when you zero your trip mileage when you fill up with petrol.
(press top button of right hand stalk).
Scroll through trip mileage/ averages etc until you get to the change oil message and then clear it the same way you clear your trip mileage by holding the button in until the message flashes & clears.
Here’s how to do it yourself in no time works on a few different Jags….
Service Light Reset Instructions:
1 . Insert key into ignition.
2 . Press and hold the Reset switch (located on the Trip Computer Switchpack ).
3 . NOTE: The reset switch has to be released immediately after the ignition is switched ‘ON’. This is critical to enable the rest of the procedure.
Turn the key to Ignition position II and at the point of entering Ignition position II (i.e when a click is heard), instantaneously release the Reset switch.
4 . Wait one second.
5 . Press and hold the Trip switch (located on the end of the left-hand side stalk).
6 . Wait one second.
7 . Press and hold the Reset switch (whilst still holding the Trip switch).
8 . The cluster should display (within three seconds) the warning message ‘RESETTING SERVICE MODE’.
9 . Keep both buttons pressed until the warning message changes to ‘SERVICE MODE RESET’ (after ten seconds).
10 . Once the message is displayed the buttons may be released — sequence is now complete.
11 . If a Service Required message was displayed prior to the reset sequence, cycle the ignition to ‘Off’ and then back to Ignition position II and check that the message is no longer displayed.