Service light reset is as follows:-
1. Press and Hold the Odometer knob in
2. Turn the ignition on (do not start the car though)
3. Turn the odometer knob to the right and hold for about 5 secs.
4. Release odometer knob and switch ignition off.
5. Start car, Service indicator should now be gone.== Answer ==
cheers for the info worked first time probably saved me a few quid putting the car to a dealers.
ta much!
this worked on a 2000 modal with out a problem
First you press the odometer button then at the same time you put the key in “on” no engine running, wait for 30 secs aprox and it will be reset, repeat this steps for the oil light
what is the odometer button
If that spanner symbol has come up on your dashboard then it’s time your car was due a service. The symbol is just a periodic reminder, it doesn’t actually come up to denote a fault – the ‘check engine’ symbol does that.
If you service the car yourself and want to reset it or your garage has forgotten to reset it, you can do it yourself quite easily with the following simple steps:
This will work with the following models:
Peugeot 106 (1999 on)
Peugeot 206 (1998 on)
Peugeot 306 (1996 on)
Peugeot 307 (1996 on)
Peugeot 406 (1998 on)
Peugeot 607 (2000 on)
Peugeot 806 (1999 on)
Peugeot Expert (1999 on)
Peugeot 807 (2002 on)
Peugeot Partner (1999 on)
Peugeot Boxer (2002 on)
Procedure to Reset Peugeot Service Light as follows:
1. Switch the Ignition Off
2. Press and hold the tripmeter (mileage reset) button on the dash
3. Now switch the ignition to the ON position
4. Keep the button pressed for 10 seconds
5. The display will read ‘0’ and the service symbol will extinguish. Job done.
Audi A2 (2000-2005), A3 (2000-2003), A6 2000 to 2004)
For Fixed Interval servicing, you can use the following procedure:
Start with the ignition turned OFF
Press and hold the button on the right side of the display while turning the ignition on (position 2)
“SERVICE IN xxx Miles / Kilometres” or “SERVICE !” should be displayed on the dashboard
Release the button on the right
To reset on the existing service schedule, press and hold the button on the left side of the display until the NEW distance or time value appears
Release the button on the left
Turn off the ignition
Turn the Ignition ON (position 2) but do not start the engine
Within 100 seconds of turning the key, press the accelerator pedal to the floor and hold it down
While still holding down the accelerator, press and release the brake pedal twice, then press it a 3rd time and hold it down
Release both pedals
Within around 10 seconds, the Oil Service warning light should turn off
Immediately Turn Ignition OFF, then within 3 seconds turn it back ON (position 2)
Turn Ignition back OFF to complete