Oil service reset Dodge Country, 2008, 2009, 2010.
Turn the ignition to run (one position before starting engine).
Fully depress the accelerator pedal slowly three times within 10 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.
Instructions
1.Sit in the driver’s seat of the XL7. Insert the ignition key and turn it to “RUN.” Do not start the engine.
2.Press and release the gas pedal three times within five seconds. Watch for the engine oil light to flash, indicating that the system is reset.
3.Turn the key to “OFF” and remove it from the ignition.
1. Turn the ignition key to ON but do not start the engine.
2. Slowly depress the accelerator to the floor and release it three times within 10 seconds.
3. Turn the ignition key to the OFF position.
To reset the oil change indicator system (after
performing the scheduled maintenance), refer to the
following procedure:
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
Many Jeep vehicles track the intervals between oil changes to alert the driver when the next oil change is needed. A light illuminates on the control panel when the internal system determines it is time for an oil change. Most Jeep mechanics reset the oil light as part of the oil change service. If you change the oil in your Jeep yourself, you can manually reset the oil light. Resetting the oil light after an oil change allows the system to accurately track the time until the next oil change is needed. The procedures described in this article apply to 2010 Jeep models.
Instructions
1.Turn the ignition switch to the “ON” position. Do not start the engine.
2.Press the accelerator pedal completely to the floor slowly three times within a 10-second span.
3.Turn the ignition switch to the “OFF” position.
4.Turn the ignition switch to the “ON” position again. The oil light should be off. If the oil light is still illuminated, repeat the previous steps.