Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

stalk

Renault Scenic service indicator light reset

To reset the service indicator on the scenic II is as follows:
Scroll through the trip computer using the button on the end of the right hand stalk control until you get to the miles till service indicator (or the “change oil soon message” will appear if due)
Then press and hold the same button in and hold it. The miles indicator will then flash then change to 18000, keep the button pressed until the 18000 stops flashing.

NOTE: If the word “service” appears on your dash then that does NOT mean that a service is due. It is an indication that the vehicle is faulty and has a stored major fault code.

The indicator that a Service is due is when the words “change oil soon” appears or the spanner starts flashing.

How to reset service light on 1997 to 2005 Renault Clio 2 – 1.2

Engine should be off, hold down both buttons at the end off stork.

Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.

If it’s just the spanner flashing on the dashboard then it’s easy to reset.

Scroll through display using button on end of wiper stalk until you get to the remaining mileage.

Press and hold button until display flashes to new service mileage.

Keep button held until the spanner stops flashing and let go of button.

Turn ignition off and on to check, bingo!!

You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again

Renault Laguna 2 service light reset

With the ignition on, Press the end of the wiper stalk until miles to service appears on the dash screen.

Now, press and hold the mileage reset button on the instrument binnacle for more than 5 seconds, it will start to flash. Let go. This will reset your miles to service to the factory setting and get rid of the flashing spanner!

Renault Laguna 2 service light reset

With the ignition on, Press the end of the wiper stalk until miles to service appears on the dash screen.

Now, press and hold the mileage reset button on the instrument binnacle for more than 5 seconds, it will start to flash. Let go

This will reset your miles to service to the factorysetting and get rid of the flashing spanner !

Hope this helps a few people.

Categories





Copyright © 2013. All Rights Reserved.