Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don’t start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows ‘Service Due’ press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.
S80
Turn ignition switch to position I
Press and hold “day counter reset button”
Turn ignition to position II
Continue holding day counter for about 10 seconds
While SRL flashes, release day counter button
Should hear “beep-beep” to confirm command accepted
Engine should be off, hold down both buttons at the end off stork.
Switch on still holding buttons down then switch off then press buttons ten times. The new mileage will show.
If it’s just the spanner flashing on the dashboard then it’s easy to reset.
Scroll through display using button on end of wiper stalk until you get to the remaining mileage.
Press and hold button until display flashes to new service mileage.
Keep button held until the spanner stops flashing and let go of button.
Turn ignition off and on to check, bingo!!
You can reset the SERV/MIL light by disconnecting battery negative for 20 seconds but you need to recode your radio, and if fault is still active it will come back on again
The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
Switch ignition on.
Press reset button until “spanner “ symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).
The reset button is located under the speedometer on the instrument cluster.
Switch ignition on.
Press reset button until “spanner” symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL)