Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

Instructions

Reset the Oil Life on My Suzuki XL7

Instructions

1.Sit in the driver’s seat of the XL7. Insert the ignition key and turn it to “RUN.” Do not start the engine.

2.Press and release the gas pedal three times within five seconds. Watch for the engine oil light to flash, indicating that the system is reset.

3.Turn the key to “OFF” and remove it from the ignition.

Turn Off an Oil Light on a 2005 KIA Spectra

Instructions

1. Pull the vehicle over to a safe area, if the light comes on while driving. If you are very close to a store that sells motor oil, stop there. Do not continue driving with the indicator light lit, as severe engine damage may occur.

2. Turn off the vehicle’s engine and open the hood. Locate the oil filler cap and oil dipstick on the top-front of the engine.

3. Check the engine oil level on the oil dipstick. If the engine oil is low, remove the oil cap and add oil until the oil level on the oil dipstick reaches the “Full” mark.

4. Replace the oil cap and restart the Kia. The oil light should turn off within a few seconds of starting the vehicle.

Reset the Range Rover Airbag Fault Code

Instructions

1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.

2. Slide the clamp off of the negative battery terminal.

3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.

4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.

Reset the Service Lights on a BMW 1-Series

Many models in the BMW 1-series are equipped with a maintenance system that monitors driving conditions to calculate when regular maintenance should be completed. When the computer determines it is time for regular service, a reminder light is illuminated on the control panel. After the scheduled service is performed, the service lights should be reset in order for the computer to accurately track when the next service will be due.

Instructions

1. Insert the key into the ignition.

2. Press the “Start/Stop” button. Wait for the service reminder lights to turn on and off.

3. Press and hold the trip odometer “Reset” button.

4. Release the “Reset” button when the service menu appears.

5. Press the “Menu” button on the end of the turn signal arm to move through the menu until the service reset option is highlighted.

6. Press and hold the “Reset” button until the service light resets.

Reset the Service B in a Mercedes C230

When a service is needed based on the car’s mileage or time since the last service, the display screen on a Mercedes C230 will notify you. The display screen is located within the speedometer on the instrument panel. Mercedes mechanics will reset the Service B notification light after the service is performed. If you performed the service, you need to reset the light yourself. Service B includes an oil and filter change, a tire rotation and other maintenance checks.

Instructions

1. Insert the key into the ignition and turn it until the battery comes or the engine turns on.

2. Locate the left and right arrow buttons on the left side of your steering wheel. Press either button until the mileage is displayed on the instrument panel display screen.

3. Press the up or down button until the service symbol appears on the screen.

4. Locate the trip odometer reset button to the left of the instrument panel. Hold the reset button for a few seconds until the screen displays the message, “Do you want to reset the service interval? Confirm with the R-button.” Release the button once the phrase appears.

5. Press the reset button to reset the Service B notification.

Categories





Copyright © 2013. All Rights Reserved.