Reset service light indicator Renault Safrane. How to reset maintenance light, reset oil service light. Can be made manually by use button on car dash board.
Reset service light indicator Renault Safrane. It was built in years: 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000.
1. The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
2. Turn ON the ignition, do not start the vehicle.
3. Push reset button until Spanner warning light symbol will start flash.
4. Keep button depressed until Spanner warning light symbol stops flashing and remains illuminated.
5. Indicator shows appropriate service interval.
6. Release reset button.
7. Turn OFF the ignition and then start your Renault Sfrane to see if spanner warning light has been reset.
Note. Some vehicles are fitted with a SERV lamp, this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).
This procedure is for the Vauxhall Zafira A Service (INSP) Light Reset
With your left hand press and hold the trip reset button.
With your right hand insert key into the ignition.
Turn key to position “II” ignition lights on engine NOT started.
Keeping the trip reset button pressed you will see “INSP” and after a while “_ _ _” will be displayed.
Turn key to the “OFF” position thn release the trip reset button.
Turn key to position “II” ignition lights on engine NOT started.
That completes the service light reset for the Vauxhall Zafira A.
R P SERVICES would like to state that this process should only be used after the vehicle has been serviced.
Hot to reset service light on a Seat Inca
Try this.
Switch on the ignition.
Press the left hand button on the clocks and hold it in while switching off the ignition.
Release the button and you should be able to toggle between the oil, insp1 and insp2 indicators.
Choose the one you want to reset.
On the right hand side of the clocks there is two buttons.
Press and hold the bottom button with a biro and hold it until the display is reset.
The reset button is located on the bottom right hand side of the Rev counter on the instrument cluster.
Switch ignition on.
Press reset button until “spanner “ symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains illuminated.
Indicator shows appropriate service interval.
Release reset button.
Switch ignition off.
Some vehicles are fitted with a ‘SERV’ lamp – this is not a service interval indicator lamp, it is a malfunction indicator lamp (MIL).
2002
Turn key in steering lock to position 2.
Press either of the lower two system select buttons on left hand side of steering wheel (looks like 2 over lapping file folders) until the trip and main odometer display appears.
Press either of the top buttons on steering wheel (arrows) until the FSS indicator appears.
Press R button on the instrument cluster for 2-4 seconds.
The display reads “DO YOU WANT TO RESET SERVICE INTERVAL? CONFIRM BY PRESSING R”.
Press R button on the instrument cluster again and hold until signal sounds (about 10 seconds). Message now reads “SERVICE INTERVAL HAS BEEN RESET”.
2003
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator appears in the multifunction display.
Press the reset knob for about 4 seconds. The message appears in the tachometer “DO YOU WANT TO RESET SERVICE INTERVAL? CONFIRM BY PRESSING R”.
To confirm, hold down the reset knob until you hear a signal. The service indicator now displays the reset interval.
2004
Turn on the ignition (standard display of the control system appears).
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator appears in the multifunction display.
Press the reset knob for about 3 seconds. The message appears in the tachometer “SERVICE INTERVAL? RESET WITH R BUTTON FOR 3 SEC.”.
To confirm, hold down the reset knob until you hear a signal. The service indicator now displays the reset interval.