1.Switch ignition on
2.Keep pushing the button that reads ‘step’ on the centre console untill the display shows the service interval.
3.Press the reset button for 3 seconds.
1996-1997
Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the CHANGE OIL SOON indicator flashes 2 times, the system is reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1998-2004
With Driver Information Centre:
Turn the ignition to run (one position before starting engine).
Press the trip calculator MODE button until the light appears next to OIL LIFE.
Press and hold the trip calculator RESET button until the oil life percentage changes to 100%.
Turn the ignition off and then start the engine to verify the indicator has been reset.
Without Driver Information Centre:
Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the CHANGE OIL SOON indicator flashes 2 times, the system is reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2005-2010
Turn the ignition to run (one position before starting engine).
Press the OPTIONS button on the Driver Information Centre until ENGINE OIL MONITOR appears on DIC screen.
Press the SET/RESET button to reset the system. The next screen indicates that the engine oil monitor system has been reset. If the vehicle is equipped with the trip computer DIC, when the GAUGE button is pressed and the OIL LIFE REMAINING mode appears, it should read 100% OIL LIFE REMAINING appears, it should read 100 percent OIL LIFE REMAINING.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1999-2003
Turn the ignition to run (one position before starting engine).
Press the RESET button (in fuse panel block inside driver side door)and release. The CHANGE OIL indicator will start flashing.
Press and hold the RESET button until audible chime is heard and then release.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2004-2005
Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. The reset is complete when you hear the chimes and the CHANGE OIL light goes out.
Turn the ignition off and then start the engine to verify the indicator has been reset.
Aspen, Commander, Compass, Dakota, Grand Cherokee, Journey, Liberty, Nitro, Ram, Wrangler
2008-2010
Turn the ignition to run (one position before starting engine).
Fully depress the accelerator pedal slowly three times within 10 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2006-2010
Turn the ignition to run (one position before starting engine).
Press SELECT to change the oil life start value. OIL LIFE START VALUE SET TO XXX% will be displayed.
Press and hold the RESET control for two seconds and release. Oil life is set to 100% “OIL LIFE XXX% HOLD RESET IF NEW OIL” is displayed.
Press and hold the RESET control for three seconds and release. Oil life is set to 100% and “OIL LIFE START VALUE SET TO XXX%” is displayed.
Turn the ignition off and then start the engine to verify the indicator has been reset.