1997-1998
Turn the ignition to run (one position before starting engine).
Press the RESET button for 5 seconds.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1999
Turn the ignition to run (one position before starting engine).
Press the SETUP control to access the System Check function. Press RESET to start the system check function.
Press and hold the RESET control when “OIL LIFE XX% HOLD RESET NEW” is displayed.
After a successful reset, the message centre will display “OIL LIFE RESET TO 100%”.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2000-2003
Turn the ignition to run (one position before starting engine).
Press the SETUP control to access the System Check function.
Press and release the RESET control to display OIL LIFE XX% HOLD RESET NEW.
Press and hold the RESET control for 2 seconds to display IF NEW OIL HOLD RESET.
Press and hold the RESET control to display OIL LIFE SET TO 100%. Your oil life is now reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2008-2010
Turn the ignition to run (one position before starting engine).
Press and release SETUP to display “OIL LIFE XXX% HOLD RESET = NEW”.
Press and hold RESET for 2 seconds and release to reset the oil life to 100%.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2010
Turn the ignition to run (one position before starting engine).
Press and release SETUP to display “OIL LIFE XXX% HOLD RESET = NEW”.
Press and hold RESET for 2 seconds and release to reset the oil life to 100%.
Turn the ignition off and then start the engine to verify the indicator has been reset.
2005-2007
Turn the ignition to run (one position before starting engine).
Press the STATUS control to access the System Check function.
Press RESET to reset oil %.
Press and hold the RESET control to set to 100%. After a successful reset, the message centre will display OIL LIFE SET TO 100%.
Turn the ignition off and then start the engine to verify the indicator has been reset.
1. Pull the hood release to open the hood. Prop it up with a rod and locate the battery under the hood.
2. Find the negative battery terminal. You will see a clamp with a nut on it. Loosen the nut with an adjustable wrench and slid the clamp off of the battery terminal.
3. Wrap a towel around the negative battery clamp and keep it away from the battery altogether. The towel will help to protect you and the battery.
4. Let the vehicle sit for about 15 minutes. This will allow the computer to reset and erase all trouble codes.
5. Discard the towel and put the negative battery clamp back onto the negative battery terminal. Tighten the nut with the wrench. Tuck the rod away and lower the hood of the car.
6. Put the key into the ignition and start the engine. Verify that all service and warning lights have turned off.