1. Turn the ignition key to ON but do not start the engine.
2. Slowly depress the accelerator to the floor and release it three times within 10 seconds.
3. Turn the ignition key to the OFF position.
Many Jeep vehicles track the intervals between oil changes to alert the driver when the next oil change is needed. A light illuminates on the control panel when the internal system determines it is time for an oil change. Most Jeep mechanics reset the oil light as part of the oil change service. If you change the oil in your Jeep yourself, you can manually reset the oil light. Resetting the oil light after an oil change allows the system to accurately track the time until the next oil change is needed. The procedures described in this article apply to 2010 Jeep models.
Instructions
1.Turn the ignition switch to the “ON” position. Do not start the engine.
2.Press the accelerator pedal completely to the floor slowly three times within a 10-second span.
3.Turn the ignition switch to the “OFF” position.
4.Turn the ignition switch to the “ON” position again. The oil light should be off. If the oil light is still illuminated, repeat the previous steps.
Turn the Ignition ON (position 2) but do not start the engine
Within 100 seconds of turning the key, press the accelerator pedal to the floor and hold it down
While still holding down the accelerator, press and release the brake pedal twice, then press it a 3rd time and hold it down
Release both pedals
Within around 10 seconds, the Oil Service warning light should turn off
Immediately Turn Ignition OFF, then within 3 seconds turn it back ON (position 2)
Turn Ignition back OFF to complete