Fiat
How to reset oil change light indicator reset maintenance light without using a computer for Fiat
How to reset oil change light indicator reset maintenance light without using a computer for Fiat
2012
1. Turn the ignition to run (one position before starting engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.
Think you press the trip bottom on the dash, whilst turning the ignition on, and hold it down for 10 seconds.
1. Turn the ignition switch to the “On” position without starting the engine.
2. Press the odometer reset button repeatedly until the total mileage is displayed.
3. Turn the ignition switch to “Off.”
4. Press and hold the trip odometer reset button.
5. Turn the ignition switch to “On.” Do not start the engine.
6. Release the trip odometer reset button after the service display counts down from 10 to 0 and the service light resets.
Switch Ign on (do not start engine)
Set Odometer to read total miles.
Press Odometer Button (OB) until CFG1 appears in display
Release the OB.
Pressing the OB briefly will change between CFG1, CFG2, CFG3, CFG1
Once you have selected the CFG (see below).
Press the OB again for 5secs to store the new service frequency.
Turn off the ignition.
I selected CFG1 for my vehicle (05 Reg 2.8JTD), but you must decide yourself for your vehicle, should take 5mins to read this and carry out the resetting procedure
Note: If your vehicle is under warranty and you take it to be serviced by a Fiat dealer they will do this as part of the service.
CFG1 = 30000km (18,600mi) and 365 days in cases of Standard Use for 2.0 petrol and 2.8JTD versions, or in the case of Severe Use for the 2.3JTD versions.
CFG2 = 20000km (12,500mi) and 365 days in case of Standard Use for 2.0JTD versions, or in case of severe use for 2.0 petrol and 2.8JTD versions
CFG3 = 15000km (9,300mi) and 365 days in case of Severe Use for 2.0JTD versions
1) Ensure ignition key is turned off.
2) Press and hold the odometer reset button whilst turning the ignition switch to the on position.
3) Keep the odometer reset button pressed for 10 seconds whilst the service display counts down from 10 to 0. When the count down reaches zero the spanner icon will vanish from the display and the service indicator will be reset.