Reset oil service, maintenance light reset, oilreset

Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

Toyota Tacoma reset service light

1. To reset MAINT reminder light after engine oil replacement, turn ignition switch to OFF position with odometer showing ODOMETER READING. Turn ignition switch to ON position while holding down trip meter RESET button.

2. Hold trip meter RESET button down for at least 5 seconds until odometer indicates “000000” and MAINT reminder light goes out.

How to Reset the Service Light on the Volvo S70

Put the key into the ignition and turn it to position “I.”
Press the trip odometer button in and hold it. Turn the ignition key to position “II.”
Wait about 5 seconds until the service engine light begins to blink. After the 4th blink, turn the ignition key back to position “I.”
Release the button and start the engine. The light should have turned off. If not, repeat steps 1 through 4 again.

service light reset Audi A3 (1996-1999), A4 (1994-2001), A6 (1996-2000)

If the service is due on these vehicles, when the key is turned to position 2, one of the dashboard displays will show “Service INSP”, “INSP1” or “INSP2” for Fixed interval services, and “SERVICE OEL / OIL” for the Oil Service interval.
The oil service reset procedure is as follows:
Start with the ignition turned OFF
Press and hold the button on the right side of the display while turning the ignition on (position 2)
“Service OEL / OIL” should be displayed
Release the button on the right
Pull out the button on the left side of the display until the service prompt is cleared
The display should now read —
Release the button on the left

…then to access and reset the service information:

Push the button on the right briefly
“Service INSP” should show on the dash
Pull out the button on the left side of the display until the service prompt is cleared
The display should now read —
Release the button on the left
Turn off the ignition

service light reset Audi A2 (2000-2005), A3 (2000-2003), A6 2000 to 2004)

Audi A2 (2000-2005), A3 (2000-2003), A6 2000 to 2004)

For Fixed Interval servicing, you can use the following procedure:
Start with the ignition turned OFF
Press and hold the button on the right side of the display while turning the ignition on (position 2)
“SERVICE IN xxx Miles / Kilometres” or “SERVICE !” should be displayed on the dashboard
Release the button on the right
To reset on the existing service schedule, press and hold the button on the left side of the display until the NEW distance or time value appears
Release the button on the left
Turn off the ignition

service light reset Audi A3

Audi A3 (2003-2009)

For Fixed Interval servicing, you can use the following procedure:
Start with the ignition turned ON (position 2), but with the engine OFF
Pull out and hold the button on the right side of the display until “SERVICE” appears on the display
Release the button on the right, then within 5 seconds pull the button out and hold it again
Release the button when the display shows “- – -” or “SERVICE IN xxxx Miles / Kilometres, xxxx days”
Turn off the ignition

Categories





Copyright © 2013. All Rights Reserved.