Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

Diagnostic Reset Tool

Oil Service Reset Audi TT

2000-2004
*Diagnostic Reset Tool Required

Manual Reset using DIS and Reset Knobs:

1. Turn off the ignition
2. Locate the Driver Information System (DIS) in the instrument panel.
3. Do the following to display the SERVICE! message in the display.
i) Press and hold the right RESET knob.
ii) Turn on the ignition – do not start the engine.
iii) Release the knob.
4. Do the following to display the next service interval (SERVICE IN ##MI)
i) Press and hold the right RESET knob.
ii) Release the knob.
5. Turn off the ignition.
6. Start the engine and verify indicator has been reset.

Manual Reset for 2000 only:

1. Turn off the ignition.
2. Press and hold the TRIP RECORDER reset button on the instrument cluster and turn on the ignition.
3. Release the button. The display will show SERVICE IN —MI or SERVICE.
4. Within 5 seconds
5. Turn off the ignition.
6. Start the engine and verify indicator has been reset.
2005-2007
1. Turn off the ignition.
2. Press and hold the button to the right of the LCD display in the instrument cluster.
3.Turn the ignition on (do not start the engine); the message “”SERVICE”” appears. Release button.”
4. Within 5 seconds
5. Turn off the ignition.
6. Start the engine and verify indicator has been reset.

2008-2012
“Audi recommends the use of a reset tool. *Depening on model

Service oil reset Mini Cooper/S

2002-2006
*Diagnostic Reset Tool Required (please refer to TOOLS page)
2007-2010
*Diagnostic Reset Tool Required (please refer to TOOLS page)
Manual Reset:
Turn ignition to Terminal 15 which is one turn of the key or one press of the START/STOP button.
Press and hold the trip odometer reset button for approximately 10 seconds until the first service job appears in the display.
The upper display in the Instrument Cluster will be illuminated with a Service Item (example: An oil can is the designation for Oil Service). The lower display in the Instrument Cluster will indicate the remaining time or mileage left for that Service Item (example: 14000). Press the on-board computer button repeatedly (located on the direction indicator/main-beam switch) to scroll through all of the Condition Based Service Items.
Press and hold the on-board computer button on the direction indicator/main-beam switch until “RESET” appears in the lower display.
Pressing the on-board computer button again resets the service shown in the upper display. Repeat the procedure for each additional service which is to be reset.
Turn the ignition off and start the engine to verify the indicator has been reset.

Categories


Copyright © 2013. All Rights Reserved.