Find how to reset any maintenance light or reset oil life after an oil change for all makes and models.

Oil service reset Chevrolet GMC Trucks Suburban/Tahoe/Yukon

2000-2006

Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
If the Change Oil Soon light flashes the system is resetting.
Turn the ignition off and then start the engine to verify the indicator has been reset.

2007-2010

Turn the ignition to run (one position before starting engine).
Display the OIL LIFE REMAINING on the DIC (i button). If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display by pressing the trip odometer reset stem.
Press and hold the SET/RESET (check mark) button on the DIC , or the trip odometer reset stem if vehicle does not have DIC buttons for more than 5 seconds. The oil life will change to 100%.
Turn the ignition off and then start the engine to verify the indicator has been reset.

or

Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
Display the OIL LIFE REMAINING on the DIC. If the display shows 100%, the system is reset. If the vehicle has a CHANGE OIL SOON message this should be off.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Leave a Reply

Your email address will not be published. Required fields are marked *

 

Categories





Copyright © 2013. All Rights Reserved.